Jump to content
groovyPost Forums

Setting up VPC Networking as Windows7/host &WidnowsXP/Client

Guest Meshi

Recommended Posts

Hi, I’m a beginner in networking, so I might not explain my situation very well..


I’m trying desperately to establish a network connection between a real computer and a virtual one.. (all on my laptop)

and the main purpose of this network is to make two programs coded in Python communicate with each other through the network (I'm not concerned about sharing the Internet access)


The virtual program that I’m using is (Virtual PC 2007)

The host (Physical computer) is running on Windows7 Home Premium

The client (Virtual computer) is running on Windows XP SP3


After hundreds attempts to find tutorials explaining the setup of network connection between these computers, I found an article by Austin Krause which explains exactly what I wanted to do:

http://www.groovypost.com/howto/microso ... apter-ics/

All the steps were applied and went very well, but the result wasn’t!!

No network connection was established!! :cry:


I also tried the ping command (this term was very new to me), I think it shows me that there was no successful connection between the computers because it says the sent packets from the host to the client was Zero..


If you need the ping output information, I've post them below

Ping for Client:




Could you tell me what went wrong?

Thank you,


Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...